Motorola Solutions MSC-111 Exam Syllabus Topics:
| Section | Weight | Objectives |
|---|---|---|
| Site Survey and Implementation | 5% | - Grounding and environmental considerations - Site requirements and antenna placement |
| PTP System Design | 30% | - Timing and synchronization - Frequency selection and interference mitigation - Link planning and path analysis - FTP and PTP product portfolio |
| Network and Service Integration | 15% | - VLAN, QoS and IP routing - Security and management |
| PMP System Design | 30% | - PMP 100/400 series architecture - Sector planning and capacity design - Authentication and encryption - Access Point and Subscriber Module deployment |
| Wireless Broadband Fundamentals | 20% | - RF principles and spectrum
|
Motorola Solutions Design Point (PTP and PMP) Solutions Sample Questions:
1. A customer has a number of PMP business clients, located 8 km (5 miles) away from a tower. The SMs are operating in lx mode using equipment at the maximum allowable EIRP.
What would be required to provide service in 2x or 3x mode to these clients?
A) Install narrow beam-width antennas at the client sites
B) Disable lx mode and only allow 2x and 3x mode
C) Install new SM equipment with output greater then the allowable EIRP and lower the AP power output accordingly.
D) Install an additional PMP cluster close enough to the clients to provide 2x or 3x service
2. When deploying multiple licensed Motorola FTP radios on the same tower, what co- location design procedure should be used?
A) Cross connect the RCA ports on all of the FTP ODU's (Outside Data Unit). Set one ODU as master and the others as slave
B) Install a CMM to provide GPS timing for all links
C) Enable automatic frequency selection (AFS) to allow links to self coordinate frequencies
D) Use a frequency co-ordination software program or service company to design a non- conflicting channel plan
3. A bank requires a redundant FTP link. The bank has a single unused license for 11GHz using vertical polarization and has space on its towers for a single set of dishes. What method if any, can be used to implement this link using this license with the least signal loss?
A) Use a dual polarized dish and implement two 1+0 links for redundancy
B) The requirement exceeds the capability of the licence. The bank will need to apply for an additional license
C) Using an antenna coupler, implement 2+0 redundancy on link using the existing license
D) Using an antenna coupler, implement 1+1 redundancy on link using the exiting license
4. A customer with an existing Motorola PMP deployment has installed the same type equipment in another country. The customer is concerned as the coverage pattern, using the same antennas, is significantly different at the new location. Given the options below, what is MOST likely the cause?
A) Different climate conditions have effected the coverage range
B) Minimum radio power outputs for the new location are different
C) Different regional regulatory standards have changed the allowable EIRP of the equipment
D) The new location requires different antenna patterns for the equipment
5. Oceanside Information
The community of Oceanside is interested in obtaining a broadband access solution to all of the homes in the neighborhood. There is no fiber access in the neighborhood; however there is fiber near the entrance to the neighborhood on Highway A1A. The neighborhood association has requested that the proposal not have any tear-up of the existing roads.
The anticipated service area is approximately 1/2 x 1/3 miles.
Click on the Exhibit button to access the "Oceanside Map" and the "RFP Requirements"
Given the customer requirements in the RFP and the Oceanside Map, if your proposal is based on a Point-to-Multipoint solution with 300 Subscriber Modules and one access point cluster, how many Cluster Management Modules do you need?
A) Two
B) One
C) Three
D) Four
Solutions:
| Question # 1 Answer: D | Question # 2 Answer: D | Question # 3 Answer: D | Question # 4 Answer: C | Question # 5 Answer: B |
1297 Customer Reviews
Quality and ValueITCertKing Practice Exams are written to the highest standards of technical accuracy, using only certified subject matter experts and published authors for development - no all study materials.
Tested and ApprovedWe are committed to the process of vendor and third party approvals. We believe professionals and executives alike deserve the confidence of quality coverage these authorizations provide.
Easy to PassIf you prepare for the exams using our ITCertKing testing engine, It is easy to succeed for all certifications in the first attempt. You don't have to deal with all dumps or any free torrent / rapidshare all stuff.
Try Before BuyITCertKing offers free demo of each product. You can check out the interface, question quality and usability of our practice exams before you decide to buy.
