Cisco CCNA Cisco Certified Network Associate CCNA (803) Sample Questions:

1. Which statements describe the routing protocol OSPF? (Choose three.)

A) It increases routing overhead on the network.
B) It allows extensive control of routing updates.
C) It supports VLSM.
D) It is used to route between autonomous systems.
E) It confines network instability to one area of the network.
F) It is simpler to configure than RIP v2.

2. Which three statements about HSRP operation are true? (Choose three.)

A) The HSRP virtual IP address must be the same as one of the router's interface addresses on the LAN.
B) The HSRP default timers are a 3 second hello interval and a 10 second dead interval.
C) HSRP supports up to 255 groups per interface, enabling an administrative form of load balancing.
D) The HSRP virtual IP address must be on a different subnet than the routers' interfaces on the same LAN.
E) HSRP supports only clear-text authentication.
F) The virtual IP address and virtual MA+K44C address are active on the HSRP Master router.

3. What are three characteristics of satellite Internet connections? (Choose three.)

A) They are usually at least 10 times faster than analog modem connections.
B) They are usually faster than cable and DSL connections.
C) They require a WiMax tower within 30 miles of the user location.
D) They use radio waves to communicate with cellular phone towers.
E) They are frequently used by rural users without access to other high-speed connections.
F) Their upload speed is about 10 percent of their download speed.

4. Refer to the exhibit.

A junior network administrator was given the task of configuring port security on SwitchA to allow only PC_A to access the switched network through port fa0/1. If any other device is detected, the port is to drop frames from this device. The administrator configured the interface and tested it with successful pings from PC_A to RouterA, and then observes the output from these two show commands.
Which two of these changes are necessary for SwitchA to meet the requirements? (Choose two.)

A) The port security configuration needs to be saved to NVRAM before it can become active.
B) Port security needs to be configured to shut down the interface in the event of a violation.
C) Port security needs to be configured to allow only one learned MAC address.
D) Port security needs to be enabled on the interface.
E) Port security needs to be globally enabled.
F) Port security interface counters need to be cleared before using the show command.

5. Refer to the exhibit.

The network administrator requires easy configuration options and minimal routing protocol traffic. What two options provide adequate routing table information for traffic that passes between the two routers and satisfy the requests of the network administrator? (Choose two.)

A) a dynamic routing protocol on InternetRouter to advertise all routes to CentralRouter.
B) a static, default route on CentralRouter that directs traffic to InternetRouter.
C) a static route on InternetRouter to direct traffic that is destined for 172.16.0.0/16 to CentralRouter.
D) a dynamic routing protocol on InternetRouter to advertise summarized routes to CentralRouter.
E) a dynamic routing protocol on CentralRouter to advertise all routes to InternetRouter.
F) a dynamic routing protocol on CentralRouter to advertise summarized routes to InternetRouter.

Solutions: